In order to change the wiring harness on your Anglepoise Type 1228 product the work should be done by a qualified electrician. Firsty please firstly uplug your lamp from the electrical socket in the wall.
The following tools are required.
YOu should have the following parts for your newly supplied wiring harness.
Remove lamp holder ring to release existing shade cap.
Cut the plug on your lamp and pull the wire through the lamp arms. Please dispose of the plug immediately.
Insert the wire from the new harness back through the arms starting from the top. Use a screw driver to help feed the wire out of the first hole. Please leave approximately 7” (17.78 cm) of wire from the top of the lamp arm to the shade cap. Place the new lamp holder into the top of the shade and tighten up the lamp holder ring to secure.
Ensure the wire is facing down. Feed the remaining wire through to the bottom hole making sure the lamp can fold in half withoutstretching the wire. Rewire the plug as below.
Please dispose of the old wiring harness and plug in your local electrical recycling centre. If you also have any questions about this then please contact us