This Anglepoise product was produced between 1973 and 1985. At the time it used the latest materials of the time. This included nylon, which allowed parts to take on complex shapes that were light and cost-effective.
However, over long periods of time, these components are more prone to decay and failure compared to materials like metal.
For example, one area, like the nylon swivel ball that connects the top arm to the shade has been an issue, and after nearly 50 years of use, some are failing. You can purchase a replacement shade joint on our website here, to ensure many more years of service.
One design change that was made from the Anglepoise Model 75 to this product the Model 90 however was a nylon section in the top of the back arm to join the top arm at the centre joint this was to allow the different sections to align properly and form a joint. Some have started to fail here and so we have produced a solution that involves a 3D printed centre joint. You can purchase one of these from our website here.
Then we have the linkage parts which attach the lower spring anchor above, connecting everything to the front arms. You purchase our remanufactured replacements on our website here.
If you are looking to rewire your product there are a couple of options for you.
A rewire set can be purchased here, or a rewire service can be purchased here.
You might find the following assembly instructions interesting, and helpful in repairing your Anglepoise Model 90 product
Comments
1 comment
Terry
I am restoring an Apex 90 and I would like to rewire the bulb holder.
I can't get it apart.
I see your replacement holder is closed with a push fit design, can the original be dismantled.
I have quite good skill sets in this area but it has me stumped.
Regards
Simon
Please sign in to leave a comment.